TelescopeSystemStatus - www.iram.es Main Wiki

System - General

$/!\$ The 30-m telescope is now operating using the New Control System (NCS) (2005-11-30 HU)

[http://www.iram.es/IRAMES/ncs30m/ NCS documentation]
[http://mrt-lx1/mainWiki/ Wiki with up-to-date Notes on NCS]

NCS supports only source coordinates in Equatorial J2000.0 system. (More systems will be made available as soon as possible)

Observations near and towards the Sun are not yet supported.

NCS supports observing modes and source offsets in:

Projection "Radio" (same offsets as in old CS) in Equatorial J2000.0
"true angle" horizontal
Nasmyth (receiver offsets)

All 4 Switching Modes are supported by the NCS (total power, beam switching, wobbler switching, frequency switching.)

Observations with "rotated" wobbler and the bolometer are now possible within the pool; contact the pool manager, Stephane Leon, on how to prepare such observations. After finishing with rotated Wobbler, make sure that the operator puts the rotation back to exactly 0 degrees.

Observing modes supported by the NCS:

Calibrate (for heterodyne)
Pointing
Focus
Tip
Track
- Frequency Switching
ON-OFF
- Position Switching
- Wobbler Switching
On-The-Fly Map
- Heterodyne
  - Total Power (like Position Switching)
  - Frequency Switching
- Bolometer
  - Wobbler Switching
VLBI

Automatic calibration and processing of heterodyne data using the MIRA software is in operation for all observing modes. MIRA can also be used manually and offline.

[#beginOfPage Back to top]

Antenna

[#beginOfPage Back to top]

Wobbler

Available under NCS.

[#beginOfPage Back to top]

Pointing Model and Focus

The Pointing Model is maintained with respect to the receiver B100. The misalignment and focus error (D-focus) of the other receivers with respect to B100 is the following:

  Rx       misal.(")       date            D_focus(mm)       date
 A100     0.16 ±0.06     27-Feb-07,        +0.09 ±0.03     13-Mar-07
 A230     1.34 ±0.18     27-Feb-07,        +0.43 ±0.02     13-Mar-07
 B100     0.00                              0.00
 B230     1.74 ±0.16     27-Feb-07,        +0.40 ±0.10     17-Apr-07
 C150     1.26 ±0.24      5-Feb-07,        +0.64 ±0.13     17-Apr-07
 C270     0.78 ±0.18      5-Feb-07,        +0.36 ±0.15     17-Apr-07
 D150     1.03 ±0.13     12-Mar-07,        +0.26 ±0.02     12-Mar-07
 D270     1.40 ±0.19     12-Mar-07,        +0.18 ±0.05     12-Mar-07

heterodyne: OK, (last model update: 2007-01-31).

bolometer: OK, (last model update: 2007-01-30).

attachment:pointingCorrBolo-Dec06-Feb07small.png

Azimuth (blue triangles), Elevation (red crosses) pointing corrections with Mambo2 during the period December'06-February'07 (SL, Feb 2007)

$/!\$ Pointing on spectral line sources like SiO masers is not yet supported by the data processing.

[#beginOfPage Back to top]

SIS Receivers

A, B, C, D receivers are supported by NCS for observations.

Image/Signal gain-ratio calibration is supported by NCS.

[http://gra-lx1.iram.es/mainWiki/ReceiverGroupColdloadPlots A standard table of T_cold] calibration temperatures (same as in old CS) for A, B, C, D receivers is implemented in NCS with an additional scaling/correction factor; note that this covers only a limited standard range of frequencies. $/!\$ Outside this range, T_cold has to be set manually.

$/!\$ Temporarily, the standard calibration system for A, B, C, D receivers is out of operation. It is replaced by using a container of L-N2. For this the T_cold temperature for these receivers at all frequencies should be set to 77K; this needs to be done manually in paKo. (2007-02-16 HU).

$/!\$ Receiver C150 shows low continuum signal at the higher frequencies (>168 GHz). It has to be fully checked. Use D150 instead. (2005-11-16)

[#beginOfPage Back to top]

HERA

HERA is supported by the NCS. (2006-02 HU)

Second polarization installed. BR One previously blind pixel is now fixed (2006-04). BR SSB tuning tables for standard frequencies. BR Sideband rejections not determined (2004-12-01 AW). Use standard value of 0.1! BR

For HERA calibration, measured values of the load temperatues are automatically used!

$/!\$ Watch the computer control of the derotator closely (2002-12-22). BR $/!\$ Make sure the derotator tracking is stopped after observations, i.e, set to zero degrees in "frame". BR

HERA 2 is more noisy than HERA 1, limiting HERA2's useful frequency range to below about 242 GHz (2006-09-27 HU according to info from SN)BR

[#beginOfPage Back to top]

Pointing and Flux monitoring with SIS receivers:

Continuum instability ("ripple") can occur with all receivers, making pointing and focusing difficult.

In general some receivers are better then others in this respect as summarized here:

A100 generally OK for pointing. (2003-11-12) BR B100 OK, is best for pointing. B100 is the standard reference for the heterodyne pointing modelBR $/!\$ C150 often bad for pointing, ripple. (2002-07-16) BR D150 generally good performance for pointing.(2002-07-16) BR $/!\$ A230 often unstable, bad for pointing and flux monitoring. (2003-11-12) BR B230 OK BR $/!\$ C270 very bad for pointing at 265 Ghz. (2002-07-16) BR $/!\$ D270 can be unstable and difficult for pointing. (2002-07-16) BR
With HERA pointing may be difficult using beam switch mode - total power mode may give better results but requires excellent weather BR

[#beginOfPage Back to top]

Bolometers

Bolometer Observations are supported by the NCS.

[#beginOfPage Back to top]

Backends

Support by NCS:

Continuum Backends for heterodyne receivers
4 MHz Filterbanks
1 MHz Filterbank in parts of 256, 512, 768, or 1024 channels
100 kHz Filterbank only for receivers in "narrow" mode (this includes A100 and B100)
WILMA is supported by NCS for observations with HERA (2006-02 HU)
VESPA
ABBA for MAMBO bolometer

[#beginOfPage Back to top]

Computer/Software

$/!\$ The 30-m telescope is now operating using the New Control System (NCS) (2005-11-30 HU). Note that the NCS supports most essential features, but still has some limitations! See the NCS documentation for details, in particular links from the Wiki [https://mrt-lx1.iram.es/mainWiki/OperationNotesObservers NCS Operation Notes for Observers]

$/!\$ Online data processing, in some circumstances, still may have problems with scans extending over midnight. Please check data and report problems to Albrecht Sievers.

[#beginOfPage Back to top]

Other Items

Remote observing via VNC is available on a trial basis from Granada and Grenoble. Coordinate with Walter Brunswig.

[#beginOfPage Back to top]

Updates/History

To see the changes between the actual and the last version, please see Show Changes in the Wiki Interface. If you want to see the Revision History of this page, please see Get Info in the Wiki Interface.

[#beginOfPage Back to top]

Legend

: OKBR $/!\$ : WarningBR : ErrorBR

The wiki markup of these icons is:

{{{(./) : OK $/!\$ : Warning : Error }}}

[#beginOfPage Back to top]