OffProcNika2Run1ObsModeTests20151031

Test of mapping faint extended sources

Tests of the Observing Modes

Maps of CasA Obtained with 4 scans in AzEl @nkotf 10 10 angle 0 30 60 azel angle=0,45,90,135 20151031s6 to s9

Pako command: nkliss 6
Scan number: 20151021s22
Note: None
Pipeline version: observe@nika2-a.iram.es / branch/Nika2Obs on 2015-10-22:01:00 UT.
pipeline param:
- param.map_xsize = 650
- param.map_ysize = 650
- param.map_proj = ‘azel’
- param.decor_method = ‘COMMON_MODE'
- results: Could not reduce this scan. Even with ‘COMMON_MODE’ (i.e. not masking the source), we get the following error message: % NK_ERROR: FATAL: There are 7293 holes in the derived common_mode.

Pako command: nkotf_square 10
Scan number: 20151021s24 et 20151021s25
Note: The observation produced 2 scan files. The pipeline does not find Antenna imbfits for scan 25, so only scan 24 was reduced.
Pipeline version: observe@nika2-a.iram.es / branch/Nika2Obs on 2015-10-22:01:00 UT.
pipeline param:
- param.map_xsize = 700
- param.map_ysize = 700
- param.map_proj: = ‘azel’
- param.decor_cm_dmin = 60.
- param.decor_method = ‘COMMON_MODE_KIDS_OUT’
results:
- Ganymede and Callisto are both seen at 1mm (left) and 2mm (right) images. The measured distances are 181 arcsec for Ganymede, 250 arcsec for Callisto, and position angle (from top, leftward) of 13 degree and 11 degree respectively, a good match for this observation taken close to 05:00 UT . (Not the that the images are displayed with IDL !order = 1 so that the pixel (0, 0) of the maps are at the top, left of the displayed image. With such !order, the results are as expected. The expected position of Europa is also marked, put it is too close from jupiter.

The coverage at 2mm (grid.nhits_2) is displayed below. The total map is 11.6 x 11.6 arc min on a side. The white square shows the 10 x 10 arc min area indicated by the pako command. Within this area, the coverage is not homogenous, from 130 hits on the edge to 330 in the middle. The dashed area correspond to 250 hits and above, and is 40 square arcmin (6.3 x 6.3 arc min). Maybe we should add a Pako message saying that the homogenous coverage is closer to 6’ x 6’.

Pako command: nkotf 3 10 0 0 30 50azel
Scan number: 20151021s27
Note: None
Pipeline version: observe@nika2-a.iram.es / branch/Nika2Obs on 2015-10-22:01:00 UT.
pipeline param:
- param.map_xsize = 700
- param.map_ysize = 700
- param.map_proj: = ‘azel’
- param.decor_cm_dmin = 60.
- param.decor_method = ‘COMMON_MODE_KIDS_OUT’
results:
- In the 2mm image (left), Ganymede is found at 180”, PA=13, Callisto at 254”, PA = 10. This is in good agreement with Horizon. (again, with convention !order = 1).
- In the array 2 nhits map (right), the scanning at constant elevation is clear. The coverage is inhomogenous. The 3 x 10 arc min expected from the scan is shown by the white rectangle. The coverage in this rectangle goes from 80 to 240 hits...

Pako command: nkotf 10 3 90 0 15 50azel (i.e. scan along elevation)
Scan number: 20151021s27
Note: None
Pipeline version: observe@nika2-a.iram.es / branch/Nika2Obs on 2015-10-22:01:00 UT.
pipeline param:
- param.map_xsize = 700
- param.map_ysize = 700
- param.map_proj: = ‘azel’
- param.decor_cm_dmin = 60.
- param.decor_method = ‘COMMON_MODE_KIDS_OUT’
results:
- In the 2mm image (left), Ganymede is found at 181”, PA=12. It is barely visible. Callisto is not visible. This is due to the scanning along elevation, at a time (05:30 UT) where the satellite are almost along the scan axis (12 degree away only). This is in good agreement with Horizon. (again, with convention !order = 1).
- In the array 2 nhits map (right), the scanning at constant azimuth is clear. The coverage is inhomogenous. The 3 x 10 arc min expected from the scan is shown by the white rectangle. The coverage in this rectangle goes from 112 to 236 hits...

Pako command: nkotf 10 10 00 0 15 50 radec (i.e. scan along RA)
Scan number: 20151021s38
Note: None
Pipeline version: observe@nika2-a.iram.es / branch/Nika2Obs on 2015-10-22:01:00 UT.
pipeline param:
- param.map_xsize = 700
- param.map_ysize = 700
- param.map_proj: = ‘radec’
- param.decor_cm_dmin = 60.
- param.decor_method = ‘COMMON_MODE_KIDS_OUT’
results:
- Jupiter is not at the center of the map !!!
- Neither Ganymede or Callisto are to be seen !!!
- The following images display the map, with !order = 1 (left) and !order = 0 (right)

The following images display the Nits, with !order = 1 (left) and !order = 0 (right). The black cross marks the measured position of jupiter, and the losange (white left, black right) marks the expected position of ganymede, given its PA and distance to Jupiter. A possible reason for the non detection of Ganymede, is that it is in a region of the map with a low hits number, i.e. if the correct orientation is with !order = 0. This will be confirmed with scan 38 below.
The scan was correctly done along the X (RA) axis. But we are off center by 1/4 of the map size .

Pako command: nkotf 10 10 90 0 15 36 radec (i.e. scan along Dec)
Scan number: 20151021s38
Note: None
Pipeline version: observe@nika2-a.iram.es / branch/Nika2Obs on 2015-10-22:01:00 UT.
pipeline param:
- param.map_xsize = 700
- param.map_ysize = 700
- param.map_proj: = ‘radec’
- param.decor_cm_dmin = 60.
- param.decor_method = ‘COMMON_MODE_KIDS_OUT’
results:
- Jupiter is not at the center of the map !!!
- When displaying the image with !order = 1, Ganynede is found at 169” of Jupiter, PA = -114, Callisto is found at 258”, PA = -117. While the distances are OK, the positions angle do not match the expectation in the ICRF reference frame.

When displaying the image with !order = 0, Ganynede is found at 169” of Jupiter, PA = -66, Callisto is found at 256”, PA = -63 which match reasonably well the expectation in the ICRF reference frame.

The grid.nhits_2 confirm that the scan was done along the dec axis, but jupiter is not at the center of the map. The white square is the 10’x10’ expected map, with the cross, marking the position of jupiter. We are off by 2.5’ in RA !