Back to the NIKA2 main page

Daily Reports

2024 Mar. 5th, Tuesday

Sofia, Frédéric, Tuan-Anh and Angel at the telescope since 10:30 (hereafter, local time).

16:00-16:50; Angel: Starting system check. It was necessary to restart the BluePill for moving the telescope. DAQ started at 16:30 (lost KIDs: 18, 1, 38). Pointing on Uranus (scan 113); imbFITS files properly created. Despite we tried to keep the main dish as far as possible from solar radiation during the maintenance slot, a focus sequence check gave a possible correction far from the expected: sign of a distorted beam. End of system check and observations suspended at 16:50: Aleksej K. (OHB) requires the telescope for some tests.

18:00-00:00; Sofia and Angel: Resuming observations after OHB's tests. After doing pointing and focus on source 0736+017, we had a beam of 17.5 x 18.5. Completed repetitions of WB89-670 (1 repetition done, 1 remaining). Then switched to project 151-23 targeting cluster PSZ2G210 (5th repetition out of 6, 40 mins long). Waiting for complete relaxation of the telescope. Very stable atmosphere conditions, peak-to-peak variations below 2 Jy/beam. Moved to 0316+413 for a beam map in total power (scan 157), after pointing and focus. Moved to calibrator CRL618, set pointing 7.1 8.1. FWHM 17.16 x 18.17, calib_1scan (scan 159) with nikaw-23. Performed a skydip (scan 160). Then moved to the cluster PSZ2G206 for project 151-23, new pointing on nearby source 0735+178, set pointing 5.4 7.6. Completing final repetition of PSZ2G206 (6/6).

2024 Mar. 6th, Wednesday

00:00-06:00; Frédéric: I started with a pointing and a focus on 1045+018 (FWHM 16.8"x18.3") under nikaw-23. At 01:37 (local time), I went to project 138-23 to observe NGC4214 (2 repetitions after pointing at 1156+295), before the source went above 80 degrees. I moved to project 150-23, while NGC4214 was at zenith. I observed id321 (1 repetition after pointing at 1044+719; FWHM 16.77"x18.14"). I launched another repetition on id321 (after pointing and focus on 1044+719; FWHM 16.7"x18.48") before it went under 40 degrees. At 05:27 (local time), I finished the shift with project 138-23, performing 2 more repetitions on NGC4214, after a pointing on 1144+402 (FWHM 16.73"x18.31"). Overall, very good stability, with <rms> < 40 mJy/beam.

06:00-17:50; Tuan-Anh, Quang, Ioannis, Angel: starting with a calib_1scan scan (s35) on source MWC349 in total power. DAQ restarted in polarimetry mode (lost KIDs: 18, 2, 39). Getting pointing (redid after an hexapod error message in the ACU) and focus first on K3-50A (nikaw-23 account). FWHM 17.5" x 19.4" after focus correction. Switched to project 015-17, changed to 2200+420 (BL Lac) when its position was compliant with topo low without a round trip of the telescope. Getting a new pointing & focus correction. Focus correction set to 1.47. FWHM 17.7" x 18.0" (2 mm). Got a calib_1scan (scan 52). A total of 6 rounds on DR12OH (12 scans) and 2 rounds on Serp-SMM4 (4 scans) were obtained. Several calib_1scan maps on BL Lac and Mars, respectively, were launched between single or double rounds, depending on required pointing/focus corrections. Switching to total power at 16:40; restarting DAQ (after checking twice anomalous behaviour of the board in slot 5, crate 1; no reset needed), lost KIDs: 26, 2, 43. Alternate fog around the telescope. Pointing on Uranus, the beam at 2 mm is a bit distorted (17.3" x 19.1"). No data are available from PIIC-monitors at 1 mm: imbFITS files of the preceding polarimetry session are being created at this time. No change of focus correction. New pointing check, beam geometry is improving: FWHM 17.4" x 18.3". Sofia takes over.

17:50-00:00; Sofia: I start with a pointing and focus on 0458-020 (FWHM 17.3 x 18.9) under nikaw-23. Focus correction 1.04mm. At 18:14 (local time) I switch to project 117-23, targeting orion b. Start with pointing on 0458-020, set pointing 5 9.8. I launch the first repetition of 117-23/observe-orionb-4. Launch a new pointing in nikaw-23 on 458-020. Set pointing 4.9 8, than I go to Uranus and get a new pointing. I set pointing correction 4.2 5.4, with FWHM 17.34 x 18.71. New focus on Uranus: not successful, wind speed ~ 12m/s. Switch to source 0316-413, very bright quasar. Trying pointing and focus again. Not working. Switch to source 0954+658, so that antenna is pointing north, opposite of wind direction. Pointing on 0954+658. Tried pointing and focus, but it is not working due to high wind speed. Parking the telescope at 20h35 (local time). Wind forecast are not promising for the next hours.

attachment:scan143_corrupted.png