Diff for "DailyReports6" - www.iram.es Main Wiki

Differences between revisions 8 and 10 (spanning 2 versions)

Back to the NIKA run6 page

Go to preparation run daily reports

Preparation visit before Run6

Back to the NIKA run 6

Daily Reports

Mon 03/06

Left Grenoble by car in the morning. Andrea, Alain, Alessandro. Reached the telescope at 20h30.

Tue 04/06

During the maintenance craned up again NIKA, installed. Warm impedance test: 20mbar/min at 3 bar

Start cooling down at 13h30.

Test with VNA at 300K:

figures: VNA scans at 300K (0-8GHz). Left: 1mm array; right: 2mm array.

Installed the electronics with the cables.

figures: NIKA installed again

We have also visited the back of the antenna and in particular the receivers cabin roof for possible installation of the NIKA-2 electronics. Space available is 80cm (H) x 200cm (Width) x 100cm (Depth). In order to have enough space to work, we will use a maximum depth of 60cm. The total COAX cables length if this solution is chosen is 6-8m.

figures: Cabin top, possible place for NIKA-2 electronics.

-  ⇤ ← Revision 8 as of 2013-06-04 15:39:22 → 
  Size: 636
  Editor: NikaBolometer
  Comment:
+   ← Revision 10 as of 2013-06-04 15:46:24 → ⇥
  Size: 1279
  Editor: NikaBolometer
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 21:
-Installed the electronics,
+Test with VNA at 300K:
 Line 23:
+{{attachment:VNA_1mm.jpg||width=600}}
{{attachment:VNA_2mm.jpg||width=600}}
-Line 24:
+Line 26:
+''figures: VNA scans at 300K (0-8GHz). Left: 1mm array; right: 2mm array.''
-Line 25:
+Line 28:
+Installed the electronics with the cables.
-Line 26:
+Line 30:
-{{attachment:NIKA_back_1.jpg||width=800}}
{{attachment:nika_back_2_2.jpg||width=700}}
+{{attachment:nika_back_1.jpg||width=600}}
{{attachment:NIKA_back_2.jpg||width=600}}
-Line 31:
+Line 34:
+We have also visited the back of the antenna and in particular the receivers cabin roof for possible installation of the NIKA-2 electronics. Space available is 80cm (H) x 200cm (Width) x 100cm (Depth). In order to have enough space to work, we will use a maximum depth of 60cm. The total COAX cables length if this solution is chosen is 6-8m.  

{{attachment:roof.jpg||width=600}}

''figures: Cabin top, possible place for NIKA-2 electronics.''