|
Size: 1430
Comment:
|
Size: 1430
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 14: | Line 14: |
| Andrea in remote launched the MACs 35, 33 and 10. In local The acquisition seems OK. It's tuning. The configuration is that data are saved by archeops9 and MiniMac2 on Sami. Archeops9 saved data in local too. | Andrea in remote launched the MACs 35, 33 and 10. In local The acquisition seems OK. It's tuning. The configuration is that data are saved by archeops9 and MiniMac2 on Sami. Archeops9 saves data in local too. |
Back to the NIKA run10 main page
Contents
Friday 7th November 2014
Barbara and Alessandro arrived at the telescope at 10h30. Alignment check. It was quite off (say 2-3cm on the input window). The spot isn't at the center of M5. I think that's OK. Also a few mm off (along y, a bit too high, in x it is OK) the center of M6, but I have adjusted M5 to shot on the center of the input window. Santigao played a bit with the compressed air controller but we decided it was good that way. We decided in any case to check again the alignement (but without touching if possible) on Tuesday before starting for real.
We have now a direct cable from the main NIKA console to the NIKA switch in the computers room. We spent some time playing for feeding the cable below the floor. Not so easy but the cable now is in place and it's comfortable.
Andrea in remote launched the MACs 35, 33 and 10. In local The acquisition seems OK. It's tuning. The configuration is that data are saved by archeops9 and MiniMac2 on Sami. Archeops9 saves data in local too.
Lost connection to the cryostat first, then to the electronics. In both cases the RJ45 connectors are really not very nice. Now it's OK but at any touch we risk the The strange 1-2-3 noise disappeared. I decide to regulate the temperature at 150mK as in run8.
The noise on the resonances seems quite OK at first view.