|
Size: 376
Comment:
|
← Revision 38 as of 2009-04-16 08:26:39 ⇥
Size: 916
Comment: converted to 1.6 markup
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 1: | Line 1: |
| Heterodyne/Bolometer observing procedures with the New Control System (NCS) at the IRAM-30m: | Bolometer/Heterodyne observing procedures with the New Control System (NCS) at the IRAM-30m. The .pako extension is understood by the '''paKo''' software which produces the xml files to run the observations. Back to Pool page: PoolObserving == Bolometer == For the bolometer observations, put instructions and commands in your {{{ObsForm}}}. * The ''onf.pako'' macro allows an onOff integration, typically you can use it as: pako> @onf 20 35 (it performs a 20x60sec integration with a wobbler throw of 35") * For a complete description, check in CookbookPako <!> Don't forget '''to fill up your {{{ObsForm}}} in the DB''', it will ensure that your project is correctly observed. == Heterodyne == |
| Line 4: | Line 17: |
| == Heterodyne: == | == Snapshots == |
| Line 6: | Line 19: |
| * To setup the SIS project (PI, ProjID, Receiver, Catalogues) : attachment:setup-xxx_xx.pako * To setup the backends. * To setup a wobbler-switching procedure. * To setup a position-switching procedure. * To setup a frequency-switching procedure. |
'''Pako''' (@wbolo macro) {{attachment:pakosnapshot1.jpg}} '''Monitor''' (mopsic): example of On-Off on a secondary calibrator {{attachment:monitor-1.jpg}} |
Bolometer/Heterodyne observing procedures with the New Control System (NCS) at the IRAM-30m. The .pako extension is understood by the paKo software which produces the xml files to run the observations.
Back to Pool page: PoolObserving
Bolometer
For the bolometer observations, put instructions and commands in your ObsForm.
The onf.pako macro allows an onOff integration, typically you can use it as: pako> @onf 20 35 (it performs a 20x60sec integration with a wobbler throw of 35")
For a complete description, check in CookbookPako
Don't forget to fill up your ObsForm in the DB, it will ensure that your project is correctly observed.
Heterodyne
Snapshots
Pako (@wbolo macro)
Monitor (mopsic): example of On-Off on a secondary calibrator
