Diff for "PoolSetup" - www.iram.es Main Wiki

Differences between revisions 5 and 37 (spanning 32 versions)

Bolometer/Heterodyne observing procedures with the New Control System (NCS) at the IRAM-30m. The .pako extension is understood by the paKo software which produces the xml files to run the observations.

Back to Pool page: PoolObserving

Bolometer

For the bolometer observations, put instructions and commands in your ObsForm.

The onf.pako macro allows an onOff integration, typically you can use it as: pako> @onf 20 35 (it performs a 20x60sec integration with a wobbler throw of 35")
For a complete description, check in CookbookPako

Don't forget to fill up your ObsForm in the DB, it will ensure that your project is correctly observed.

Heterodyne

Snapshots

Pako (@wbolo macro)

attachment:pakosnapshot1.jpg

Monitor (mopsic): example of On-Off on a secondary calibrator

attachment:monitor-1.jpg

-  ⇤ ← Revision 5 as of 2005-11-25 12:37:59 → 
  Size: 345
  Editor: visitor10
  Comment:
+   ← Revision 37 as of 2008-10-28 13:41:24 → ⇥
  Size: 908
  Editor: mrt-lx16
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 1:
-Heterodyne/Bolometer observing procedures with the New Control System (NCS) at the IRAM-30m:
+Bolometer/Heterodyne observing procedures with the New Control System (NCS) at the IRAM-30m. The .pako extension is understood by the '''paKo''' software which produces the xml files to run the observations.

Back to  Pool page: PoolObserving

== Bolometer ==

For the bolometer observations, put instructions and commands in your {{{ObsForm}}}.

 * The ''onf.pako'' macro allows an onOff integration, typically you can use it as: pako> @onf 20 35   (it performs a 20x60sec integration with a wobbler throw of 35")
 * For a complete description, check in CookbookPako

<!> Don't forget '''to fill up your {{{ObsForm}}} in the DB''', it will ensure that your project is correctly observed.

== Heterodyne ==
-Line 4:
+Line 17:
-== Heterodyne: ==
+== Snapshots ==
-Line 6:
+Line 19:
- * To setup the SIS project (PI, ProjID, Receiver, Catalogues)
 * To setup the backends.
 * To setup a wobbler-switching procedure.
 * To setup a position-switching procedure.
 * To setup a frequency-switching procedure.
+'''Pako''' (@wbolo macro)

attachment:pakosnapshot1.jpg




'''Monitor''' (mopsic): example of On-Off on a secondary calibrator

attachment:monitor-1.jpg