|
Size: 1573
Comment:
|
Size: 1616
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 3: | Line 3: |
| attachment:pakosnapshot1.png | |
| Line 31: | Line 30: |
| == Snapshots: == Pako (@wbolo macro) attachment:pakosnapshot1.png |
Heterodyne/Bolometer observing procedures with the New Control System (NCS) at the IRAM-30m. The .pako extension is understood by the paKo software which produces the xml files to run the observations.
Heterodyne:
- To setup the SIS project (PI, ProjID, Receiver, Catalogues) : attachment:setup-xxx_xx.pako
- To setup the backends: attachment:backends-xxx_xx.pako
- To setup a wobbler-switching procedure: attachment:target-wsw-xxx_xx.pako
- To setup a position-switching procedure: attachment:target-psw-xxx_xx.pako
- To setup a frequency-switching procedure: attachment:target-fsw-xxx_xx.pako
- Here is a model of the line catalog, use a specific name for your project: attachment:model.lin
VESPA: Note that by default the receivers are in wide mode, except the 3mm receivers. The sky frequency that you specify appears at 598MHz in the IF which is close to the upper limit of VESPA. The receivers should be configured in narrow mode for VESPA for normal observations.
Bolometer:
For the bolometer observations, indicate the old commands in your ObsForm, we will adapt them accordingly.
The onf.pako macro allows an onOff integration, typically you can use it as: pako> @onf 20 35 (it performs a 20x60sec integration with a wobbler throw of 35")
- For the mapping indicate with the old syntax, we will adapt it.
Don't forget to fill up your ObsForm in the DB, it will ensure that your project is correctly observed.
Snapshots:
Pako (@wbolo macro)
attachment:pakosnapshot1.png