1370
Comment:
|
1736
|
Deletions are marked like this. | Additions are marked like this. |
Line 3: | Line 3: |
[[TableOfContents]] | |
Line 4: | Line 5: |
== Heterodyne: == | Back to Pool page: PoolObserving == Heterodyne == |
Line 14: | Line 19: |
/!\ Note that messages in aloop are not anymore useful since the START command create an .xml file, send it to the queue and pass to the next loop directly. | <!> '''VESPA''': Note that by default the receivers are in '''wide''' mode, except the 3mm receivers. The sky frequency that you specify appears at 598MHz in the IF which is close to the upper limit of VESPA. The receivers should be configured in '''narrow''' mode for VESPA for normal observations. |
Line 16: | Line 23: |
== Bolometer: == | |
Line 18: | Line 24: |
For the bolometer observations, indicate the old commands in your {{{ObsForm}}}, we will adapt them accordingly. | |
Line 20: | Line 25: |
* The onf.pako macro allows an onfoff integration, typically you can use it as: @onf 20 35 (perform a 20x60sec integration with a throw of 35'') * For the mapping indicate with the old syntax, we will adapt it. |
== Bolometer == For the bolometer observations, indicate the commands in your {{{ObsForm}}}. * The ''onf.pako'' macro allows an onOff integration, typically you can use it as: pako> @onf 20 35 (it performs a 20x60sec integration with a wobbler throw of 35") * For a complete description, check in CookbookPako |
Line 26: | Line 35: |
== Snapshots == '''Pako''' (@wbolo macro) attachment:pakosnapshot1.jpg '''Monitor''' (mopsic): example of On-Off on a secondary calibrator attachment:monitor-1.jpg |
Heterodyne/Bolometer observing procedures with the New Control System (NCS) at the IRAM-30m. The .pako extension is understood by the paKo software which produces the xml files to run the observations.
Back to Pool page: PoolObserving
Heterodyne
- To setup the SIS project (PI, ProjID, Receiver, Catalogues) : attachment:setup-xxx_xx.pako
- To setup the backends: attachment:backends-xxx_xx.pako
- To setup a wobbler-switching procedure: attachment:target-wsw-xxx_xx.pako
- To setup a position-switching procedure: attachment:target-psw-xxx_xx.pako
- To setup a frequency-switching procedure: attachment:target-fsw-xxx_xx.pako
- Here is a model of the line catalog, use a specific name for your project: attachment:model.lin
VESPA: Note that by default the receivers are in wide mode, except the 3mm receivers. The sky frequency that you specify appears at 598MHz in the IF which is close to the upper limit of VESPA. The receivers should be configured in narrow mode for VESPA for normal observations.
Bolometer
For the bolometer observations, indicate the commands in your ObsForm.
The onf.pako macro allows an onOff integration, typically you can use it as: pako> @onf 20 35 (it performs a 20x60sec integration with a wobbler throw of 35")
For a complete description, check in CookbookPako
Don't forget to fill up your ObsForm in the DB, it will ensure that your project is correctly observed.
Snapshots
Pako (@wbolo macro)
attachment:pakosnapshot1.jpg
Monitor (mopsic): example of On-Off on a secondary calibrator
attachment:monitor-1.jpg