Diff for "PoolSetup" - www.iram.es Main Wiki

Differences between revisions 15 and 17 (spanning 2 versions)

Heterodyne/Bolometer observing procedures with the New Control System (NCS) at the IRAM-30m. The .pako extension is understood by the paKo software which produces the xml files to run the observations.

Heterodyne:

To setup the SIS project (PI, ProjID, Receiver, Catalogues) : attachment:setup-xxx_xx.pako
To setup the backends: attachment:backends-xxx_xx.pako
To setup a wobbler-switching procedure: attachment:target-wsw-xxx_xx.pako
To setup a position-switching procedure: attachment:target-psw-xxx_xx.pako
To setup a frequency-switching procedure: attachment:target-fsw-xxx_xx.pako

$/!\$ Note that messages in aloop are not anymore useful since the START command create an .xml file, send it to the queue and pass to the next loop directly.

Bolometer:

For the bolometer observations, indicate the old commands in your ObsForm, we will adapt them accordingly.

Don't forget to fill up your ObsForm in the DB, it will ensure that your project is correctly observed.

-  ⇤ ← Revision 15 as of 2005-11-25 13:09:26 → 
  Size: 893
  Editor: visitor10
  Comment:
+   ← Revision 17 as of 2005-11-29 12:16:07 → ⇥
  Size: 1053
  Editor: visitor15
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 13:
+/!\ Note that messages in aloop are not anymore useful since the START command create an .xml file, send it to the queue and pass to the next loop directly.