Diff for "PoolSetup" - www.iram.es Main Wiki

Differences between revisions 14 and 15

Heterodyne/Bolometer observing procedures with the New Control System (NCS) at the IRAM-30m. The .pako extension is understood by the paKo software which produces the xml files to run the observations.

Heterodyne:

To setup the SIS project (PI, ProjID, Receiver, Catalogues) : attachment:setup-xxx_xx.pako
To setup the backends: attachment:backends-xxx_xx.pako
To setup a wobbler-switching procedure: attachment:target-wsw-xxx_xx.pako
To setup a position-switching procedure: attachment:target-psw-xxx_xx.pako
To setup a frequency-switching procedure: attachment:target-fsw-xxx_xx.pako

Bolometer:

For the bolometer observations, indicate the old commands in your ObsForm, we will adapt them accordingly.

Don't forget to fill up your ObsForm in the DB, it will ensure that your project is correctly observed.

-  ⇤ ← Revision 14 as of 2005-11-25 13:09:05 → 
  Size: 899
  Editor: visitor10
  Comment:
+   ← Revision 15 as of 2005-11-25 13:09:26 → ⇥
  Size: 893
  Editor: visitor10
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 1:
-Heterodyne/Bolometer observing procedures with the New Control System (NCS) at the IRAM-30m. The .pako extension is understood by the ´´´paKo´´´ software which produces the xml files to run the observations.
+Heterodyne/Bolometer observing procedures with the New Control System (NCS) at the IRAM-30m. The .pako extension is understood by the '''paKo''' software which produces the xml files to run the observations.