|
Size: 1313
Comment:
|
Size: 947
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 2: | Line 2: |
| Line 7: | Line 8: |
| * Check that imbFITS files are being produced by both the new and old systems. * Data obtained in the previous run (#74) were successfully reprocessed using the PIIC/DAFs in force (/sw/gildas/mopsic/dafs). So, the default PIIC/DAFs mentioned in the document linked below are very likely to work. Best focus offset of Ar1 wrt. Ar2 is ~ +0.5 mm, and ~ +0.2 mm for Ar3 wrt. Ar1 (see plot below; linear fits are weighted by inverse rms values). Check these focus offsets. {{attachment:reprocessed_foci_run74.png||height="500"}} |
|
| Line 9: | Line 17: |
| * Data obtained in the previous run (#74) were reprocessed using the PIIC/DAFs in force. * A note about focus corrections: data of run #74 was reprocessed with the Best focus offset of Ar1 wrt. Ar2 is ~ +0.5 mm, and ~ +0.2 mm for Ar1 wrt. Ar3 (see plot below; linear fits are weighted by inverse rms values). {{attachment:reprocessed_foci_run74.png||height="500"}} * First of all, check the focus offsets in total power after the cooldown. Over run #72 focus corrections of Ar2/1 were self-consistent and that of Ar3 was +0.3-0.4 mm displaced. On run #73, we obtained offsets of about +0.3 mm for Ar2/1 and +0.6 mm for Ar2/3. Depending on these tests, we would establish appropriate compromise values. * Beam maps to produce new DAFs/kidpars with new reference KID (Ar2, central KID). * Calib_1scan maps on flux standards in total power & polarimetry. In the latter case, get focus correction from Ar1-Ar3 average. * Small maps on point-like & extended (auxiliary) bright sources. |
* See priorities and procedures at [[https://publicwiki.iram.es/NotesRecomm_Aug2025|this link]]. |
Back to the NIKA2 Run 75 main page
Preliminaries
Check the Cryo run 87 (run #75 of NIKA2) is activated in DAQ *.ini files, as well as for the creation of imbFITS files (new & old systems).
- Check that imbFITS files are being produced by both the new and old systems.
- Data obtained in the previous run (#74) were successfully reprocessed using the PIIC/DAFs in force (/sw/gildas/mopsic/dafs). So, the default PIIC/DAFs mentioned in the document linked below are very likely to work. Best focus offset of Ar1 wrt. Ar2 is ~ +0.5 mm, and ~ +0.2 mm for Ar3 wrt. Ar1 (see plot below; linear fits are weighted by inverse rms values). Check these focus offsets.
Goals of NIKA2 run 75 (Re-commissioning of NIKA2+, fourth part)
See priorities and procedures at this link.