Size: 2606
Comment:
|
Size: 5461
Comment:
|
Deletions are marked like this. | Additions are marked like this. |
Line 1: | Line 1: |
---- [[NikaRun8|Back to the NIKA run8 main page]] |
|
Line 17: | Line 20: |
---- | |
Line 22: | Line 26: |
It's so windy: {{attachment:StupidPenguin.gif}} |
|
Line 31: | Line 37: |
{{attachment:run8LN2_1mm.png||width=1400}} | [[attachment:run8_LN2.txt | Parameter file made on LN2 on 15-Feb-2014]] |
Line 33: | Line 39: |
{{attachment:run8LN2_2mm.png||width=1400}} | {{attachment:run8LN2_1mm.png||width=700}} {{attachment:run8LN2_2mm.png||width=700}} |
Line 40: | Line 48: |
For comparison with the previous run7, we show below the noise spectra measured with the window on (equivalent rto roughly 180K background). || {{attachment:1mmnoise150214.png||width=900}} || {{attachment:2mmnoise150214.png||width=900}} || '' '''Figure.''' Left: 1mm noise. Right: 2mm noise. MADE WITH WINDOW ON CRYOSTAT. '' Here is a photo of NIKA ready to observe (courtesy of Bilal Ladjelate) {{attachment:NIKApre1stOpenPool.jpg||width=700}} ---- == Sunday 16th February 2014 == '''11h00.''' Our theoretical slot begins. Wind, snow, fog. Nothing is going to happen today. New SW version uploaded by Alain. Put heater on cryostat in fixed power instead of regulation. 23.1uW to be around 150mK but not letting it oscillate too much. '''Thermal sensitivity''' for the two arrays has been measured by lowering the T to 130mK. So the 20mK variation made 3000Hz shift on the 1mm and 300Hz on the 2mm. The sensitivities to base T are thus 150Hz/mK and 15Hz/mK for the 1mm and 2mm respectively. Considering that the noise in T measured on the thermometer is of the order of 0.02mK RMS (over 1 minute roughly time, slower/larger drifts are not counted, will be hided into the sky noise) that gives 3Hz on the 1mm and 0.3Hz on the 2mm. Small. Completely negligeable ? May be not for the 1mm at least. ---- == Monday 17th February 2014 == '''11h00.''' Nicolas and Barbara arrived. Wind still preventing moving the telescope. Cannot observe today. '''13h30.''' Acquisition has changed again. This afternoon must recompile and restart. Param file changed (one column with angle added). '''PAY ATTENTION''' ---- == Tuesday 18th February 2014 == Observers arrived too. [[attachment:NIKA_aid.doc | Document for observers to verify the status of the NIKA instrument.]] == Wednesday 19th February 2014 == '''2h00.''' Starting finally. Good Sky during the night, a few "lecture" errors (on some scans) preventing to use part of the data. Checked pointing. '''18h00.''' It seems the 1mm array is a bit less sensitive that in run7 (based in run7 on a single OTF scan on APM). We don't know exactly why, but we try to polarize the 1mm array on maximum dIdQ instead of the classical (used in run7 and in the beginning of run8) 'sinus' (minimum transmission). [[attachment:run8_.txt | Parameter file with resonances A and B centred on 'sinus', i.e. minimum transmission]] [[attachment:run8_IQ.txt | Parameter file with resonances B centred on 'sinus', i.e. minimum transmission, and resonances A on max dIdQ]] From 17h30 (Local Time) we work with the IQ parameter. The 2mm array shouldn't be affected at all. |
Back to the NIKA run8 main page
Friday 14th February 2014
10h00. Xavier and Alessandro arrive at the telescope. Among the NIKA2 collaboration, Philippe André too is on the mountain. Made a new parameter file FOR THE 2MM array ONLY (definitely need the sky for the 1mm).
Old configuration (2mm): DAC gains: 20-23-20-28-35. General niveau: 5.
New configuration (2mm): DAC gains: 20-23-20-38-55. General niveau: 5. Pixels 17-25: niv 6. Pixels 55 to 56: niv 6. Pixels 73 to 78: niv 4. Pixels 96 to 108: niv 6.
|
|
Figure. Left: old config (2mm), right: new config (2mm). MADE WITH WINDOW ON CRYOSTAT, TO BE CONFIRMED (see tomorrow) WITH LN2. DON'T USE THIS BRAIN!!
Strong (strange) 12Hz noise on some (e.g. 4-5) pixels. See tomorrow daily report for more on that.
Saturday 15th February 2014
8h00. Theoretical start of the run. Winds peaking at 40m/s, telescope stopped probably the whole morning. The ski station is closed due to the wind.
It's so windy:
9h00. LN2 in front of the cryostat window to play at least with the resonances. "Decalage" found by the new "restore tones" is good. -22kHz and -1KHz at 1 and 2mm respectively, indicating that the param file run8.txt is well representative of LN2 temperature.
NEW PARAM FILE MADE ON LN2
LN2 configuration (1mm): DAC gains: 20-23-20-30-40. General niveau: 6. Individual levels to be adjusted on the sky but it'll be difficult. Bad pixels: too difficult, see offline data analysis.
LN2 configuration (2mm): DAC gains: 20-23-20-33-50. General niveau: 5. Pixels KB021,30,41,42,111 at niv. 6. Pixels KB073-80,83,88,111,114-116,119-120 at niv.4. Bad pixels: KB033,75,76,88,109,110.
Parameter file made on LN2 on 15-Feb-2014
Figure. Top: 1mm new config (LN2). Bottom: 2mm new config (LN2). MADE WITH LN2 close to pupil, TO BE CONFIRMED ON THE SKY. When we can get it.
13h00. Wind hits 42m/s (150km/h). The telescope basement is a block of ice. Put again the window on the cryostat, "restore tones" works very well. Found a shift of -393kHz and 100kHz.
15h00. Went to the cabin to try understanding the monochromatic lines (e.g. 8Hz, 12Hz) on some pixels. Difficult to conclude since it apperars that even with the window closed (but without Al tape) you see large signals due to reflections of body temperature through the HDPE then onto the curved inner surface of the window and into the cryostat.
For comparison with the previous run7, we show below the noise spectra measured with the window on (equivalent rto roughly 180K background).
|
|
Figure. Left: 1mm noise. Right: 2mm noise. MADE WITH WINDOW ON CRYOSTAT.
Here is a photo of NIKA ready to observe (courtesy of Bilal Ladjelate)
Sunday 16th February 2014
11h00. Our theoretical slot begins. Wind, snow, fog. Nothing is going to happen today. New SW version uploaded by Alain. Put heater on cryostat in fixed power instead of regulation. 23.1uW to be around 150mK but not letting it oscillate too much.
Thermal sensitivity for the two arrays has been measured by lowering the T to 130mK. So the 20mK variation made 3000Hz shift on the 1mm and 300Hz on the 2mm. The sensitivities to base T are thus 150Hz/mK and 15Hz/mK for the 1mm and 2mm respectively. Considering that the noise in T measured on the thermometer is of the order of 0.02mK RMS (over 1 minute roughly time, slower/larger drifts are not counted, will be hided into the sky noise) that gives 3Hz on the 1mm and 0.3Hz on the 2mm. Small. Completely negligeable ? May be not for the 1mm at least.
Monday 17th February 2014
11h00. Nicolas and Barbara arrived. Wind still preventing moving the telescope. Cannot observe today.
13h30. Acquisition has changed again. This afternoon must recompile and restart. Param file changed (one column with angle added). PAY ATTENTION
Tuesday 18th February 2014
Observers arrived too.
Document for observers to verify the status of the NIKA instrument.
Wednesday 19th February 2014
2h00. Starting finally. Good Sky during the night, a few "lecture" errors (on some scans) preventing to use part of the data. Checked pointing.
18h00. It seems the 1mm array is a bit less sensitive that in run7 (based in run7 on a single OTF scan on APM). We don't know exactly why, but we try to polarize the 1mm array on maximum dIdQ instead of the classical (used in run7 and in the beginning of run8) 'sinus' (minimum transmission).
Parameter file with resonances A and B centred on 'sinus', i.e. minimum transmission Parameter file with resonances B centred on 'sinus', i.e. minimum transmission, and resonances A on max dIdQ
From 17h30 (Local Time) we work with the IQ parameter. The 2mm array shouldn't be affected at all.