1086
Comment:
|
1093
|
Deletions are marked like this. | Additions are marked like this. |
Line 18: | Line 18: |
=== === | |
Line 31: | Line 32: |
Bolometer's Observation:
The most important commands of the old system have been adapted to the NCS. Here is a typical starting sequence for the bolometer.
Setup the Bolometer
Pako> @wbolo ! Mambo2, pixel 20, short onoff (@onf4)
Sources Catalog
Pako> catalog source pool ! Setup the project source catalog BR Pako> catalog source ihet ! Setup the pointing/calibration source catalog
Pointing sources: J1419+240 not 1419+240
Focus, pointing, Skydip
=== === Pako> focus 1.1 Pako> start ! Start the focus BR Do a focus when atmospheric conditions are changing, typically after sunset/sunrise
Pako> p40 !Short length pointing for weak sources+start BR Pako> p60 !Long length pointing for strong sources+start BR Before each Onoff or map if they are larger than 30 mn.
Pako> bt !Skydip at the current azimuth+start BR Every 2 hours in stable atmospheric condition.
Before an Onoff, be sure you are pointing with the right pixel (20).