1093
Comment:
|
1456
|
Deletions are marked like this. | Additions are marked like this. |
Line 6: | Line 6: |
Pako> @wbolo !'' Mambo2, pixel 20, short onoff (@onf4)'' | Pako> @wbolo !'' Mambo2, central pixel 53, short onoff (@onf4)'' |
Line 13: | Line 13: |
Line 18: | Line 17: |
=== === | |
Line 21: | Line 20: |
Pako> set focus _sfcz_ !''Correct the focus with _sfcz_. Correction from MOPSIC (@f or @fsn for weak sources)'' |
|
Line 25: | Line 26: |
Pako> set pointing _azcor_ _elcor_ !''Correct the pointing with _azcor_ and _elcor_. Correction from MOPSIC (@p or @psn for weak source)'' |
|
Line 27: | Line 30: |
Pako> bt !''Skydip at the current azimuth+start'' [[BR]] | Pako> bt !''Skydip at the current azimuth+start'' |
Line 32: | Line 36: |
== Calibration == Pako> @wbolo Pako> catalog ihet Calibrator_Name Pako> p60 Pako> SET POINTING |
Bolometer's Observation:
The most important commands of the old system have been adapted to the NCS. Here is a typical starting sequence for the bolometer.
Setup the Bolometer
Pako> @wbolo ! Mambo2, central pixel 53, short onoff (@onf4)
Sources Catalog
Pako> catalog source pool ! Setup the project source catalog BR Pako> catalog source ihet ! Setup the pointing/calibration source catalog
Pointing sources: J1419+240 not 1419+240
Focus, pointing, Skydip
Pako> focus 1.1 Pako> start ! Start the focus BR Pako> set focus _sfcz_ !Correct the focus with _sfcz_. Correction from MOPSIC (@f or @fsn for weak sources)
Do a focus when atmospheric conditions are changing, typically after sunset/sunrise
Pako> p40 !Short length pointing for weak sources+start BR Pako> p60 !Long length pointing for strong sources+start BR Pako> set pointing _azcor_ _elcor_ !Correct the pointing with _azcor_ and _elcor_. Correction from MOPSIC (@p or @psn for weak source)
Before each Onoff or map if they are larger than 30 mn.
Pako> bt !Skydip at the current azimuth+start
Every 2 hours in stable atmospheric condition.
Before an Onoff, be sure you are pointing with the right pixel (20).
Calibration
Pako> @wbolo Pako> catalog ihet Calibrator_Name Pako> p60 Pako> SET POINTING