!****************************************************
!  $Id setup-xxx_xx.pako, v0.3, 2007.11.27 , S. Leon Exp $
!
! Name: setup-xxx_xx.pako
!**************************************************** 
! 
!
! CHANGE THE LINE CATALOG IF REQUIRED 
! DO NOT SET YOUR OWN SOURCE CATALOG!!!
!
CATALOG SOURCE  pool     ! This is the default catalog. You probably don't need to change it.
CATALOG LINE model.lin
!
! CHANGE OBS PROJ ID TO YOUR PROJECT ID (e.g. 109_05)
SET PROJECT xxx_xx         
SET PI  "A.Mozart"


RECEIVER /DISC
BACKEND  /DISC
OFFSET /clear


!
!
!
! Comment out the lines for the receivers that you don't want
! Put in your line for "line_name"
! If a receiver is used in wide band mode (i.e. with 1 GHz bandwidth),
! add "/wide" at the end. This is not necessary for the A100 and B100
! receivers.
!
! Value for the gain are average. The exact value for the 
! the gain depends on the frequency
! Use the adequate value from our Web-page 
! (http://www.iram.es/IRAMES/telescope/telescopeSummary/receiver5.html)
! or measure the gain directly with:
!     calibrate /ssb receiver_name
!     (this needs the continuum backend)
!
! 
! NOTE:
!     For usual observations with VESPA, the receivers should be configured in *narrow* mode
!
!
receiver /clear 

!receiver A100   line_name  /gain -22 db /efficiency 0.95 0.95 /scale antenna /temp l 
!receiver B100   line_name  /gain -22 db /efficiency 0.95 0.95 /scale antenna /temp l
!receiver C150   line_name  /gain -18 db /efficiency 0.93 0.93 /scale antenna /temp l
!receiver D150   line_name  /gain -13 db /efficiency 0.93 0.93 /scale antenna /temp l 
!receiver A230   line_name  /gain -15 db /efficiency 0.91 0.91 /scale antenna /temp l /width wide|narrow
!receiver B230   line_name  /gain -14 db /efficiency 0.91 0.91 /scale antenna /temp l /width wide|narrow
!receiver C270   line_name  /gain -12 db /efficiency 0.88 0.88 /scale antenna /temp l /width wide|narrow
!receiver D270   line_name  /gain -10 db /efficiency 0.88 0.88 /scale antenna /temp l /width wide|narrow  
!
!

!
!RECEIVERS WHICH ARE NOT USED NEED TO BE COMMENTED OUT 
!
backend /disconnect
backend continuum 1 1000 1000 /receiver a100
backend continuum 2 1000 1000 /receiver b100
backend continuum 3 1000 1000 /receiver a230
backend continuum 4 1000 1000 /receiver b230