[[NikaRun9|Back to the NIKA run 9]]


<<TableOfContents(3)>>


== Control and Backend Room ==

Ethernet and power connections at the end of run9: 

  * Power switch : 4 connections
    * Windows NIKA PC 
    * SAMI 
    * Mini Mac (33)
    * Mini Mac (35)


  * NIKA Router : 4 connections
    * to the IRAM network 
    * to the NIKA switch (n1 - NIKA private network)
    * to Windows PC 
    * to the power switch

  * SAMI is connected directly to the NIKA switch in the backend room
  * Min Mac (33) is connected directly to the NIKA switch (n1) in the backend room
  * Min Mac (35) is connected directly to the NIKA switch in the backend room
  * Archeops 10 is connected directly to the NIKA switch from the backend room to the control room (yellow cable). We keep this computer connected. 
  * Archeops 8 and 9 are connected directly from NIKA switch (n1) in the backend room to another NIKA switch (n2) put under the table in the middle of the control room. Then, another cable under the floor connects n2 to another switch (n3) put on the table where archeops 8 and 9 are installed. These two computers have been switched off and stored away in the backend room. '''For the next open pool we propose to change this configuration putting a at least 20m ethernet cable directly from the NIKA switch n1 to n3. 
 
n2 has been put under the floor (still connected). n3 has been stored with the computers.


== NIKA Cage  ==

  * Black plastic chest of drawers:
    * several screws, scotch, small screwdrivers, spanners, heat-shrink sleeves. 
    * material for metal bars.
    * spare mixer, filters, attenuators, ampli, small coax cables.
         ''' 2 spare NIKA arrays'''

                1mm : NICA 8e 25nm   ''' - '''    
                2mm : NICA 8f1 15nm

    * Cryogenic material : vacuum grease, o-rings, clamps, tees, reducers.

  

  * Coax for the NIKA arrays: 4 SMA, 4 semi-rigid


  * 4 pneumatic foots


  * 1 nitrogen bowl (polystyrene + eccosorb)


  * 1 preampl power supply


  * 1 Automate National Instrument


  * 1 spectrum analyser / VNA, 2652A + 2 SMA coax.


  * 1 MMR3 spare box. 


  * 1 tombak (3m) 




== Telescope Cabin ==


  * Power switch : 4 connections
    *  to the automate
    *  to the cold preamplis
    *  to the mmr3
    *  to a visible multi-socket to be used for electronic rack. 

 * Rack electronic:
    Disconnected because of the GISMO observing campaign and put at the entrance of the telescope cabin. 

 * Mcbook. It has been stored in the backend room with the others computers.   

 * Mppsync, HWP modulator, HWP, Wollaston Prism, Wire grid, gunn diode and its control electronics come back to Grenoble for treatments.