!
! emirBackend.pako (for EMIR, version for pool observing, 2009-09-03 HW)
! (Modified by MG on 2012-12-12)
!
! This template assumed that the following receiver setup has been selected:
!
! RECEIVER E090   12CO(1-0)  115.271204  UO  - ! line f SB explicit
!                /Horizontal UI              - ! USB Outer 
!                /Vertical   UI                ! USB Inner
!					       	
! RECEIVER E230   12CO(2-1)  230.537990  UI  - ! 	
!                /Horizontal UI              - ! LSB (Inner)
!                /Vertical   UI                ! LSB (Inner)
!
BACKEND /CLEAR      ! clear all backend setups
!
! Connecting the continuum backends is mandatory: we need them
! for pointing and focus.
!
!
BACKEND WILMA      /Default                   

! WILMA has 4 parts of 3.8GHz each at 2MHz resolution.
! This script connects 1 part to each EMIR subband selected. Thus:
!         WILMA1 => E090 /hor UI
!         WILMA2 => E090 /ver UI
!         WILMA3 => E230 /hor UI
!         WILMA4 => E230 /ver UI
!                                           
BACKEND 4MHz       /Default                   

! The 4MHz backend has 2 parts of 4.0GHz each at 4MHz resolution.
! This script connects 1 part to each of the first 2 EMIR subbands
!         4MHz1 => E090 /hor UI
!         4MHz2 => E090 /ver UI

! If we wanted to connect them in a different way we should use the
! following command:
!
BACKEND 4MHZ 1    /Receiver E090 Horiz UO     ! connect 1 part to E090 Ho UO
BACKEND 4MHZ 2    /Receiver E230 Verti LI     !       2nd part to E230 Ve LI

BACKEND FTS      /Default                   

! The FTS has 8 parts of 4.05 GHz each at 195 kHz resolution.
! This script connects 1 part to each EMIR subband selected. Thus:
!         FTS1 => E090 /hor UI
!         FTS2 => E090 /ver UI
!         FTS3 => E230 /hor UI
!         FTS4 => E230 /ver UI
! And the remaining 4 to the contiguous outer bands. In this case:
!         FTS5 => E090 /hor UO
!         FTS6 => E090 /ver UO
!         FTS7 => E230 /hor UO
!         FTS8 => E230 /ver UO

BACKEND FTS /FINE /Default

! If the option /FINE is used, the bandwidth of the FTS is 1.8GHz
! and the resolution 50 kHz. The connexions are exactly the same
! than in the previous case.

BACKEND VESPA  1   0.040   40.0    0.0   E090  Horiz  UI
BACKEND VESPA  2   0.040   40.0    0.0   E090  Verti  UI
BACKEND VESPA  3   0.040   40.0    0.0   E230  Horiz  UI
BACKEND VESPA  4   0.040   40.0    0.0   E230  Verti  UI

! VESPA is a versatile backend, which allows to observe with several
! combinations of bandwidths and resolutions. Please, check the 
! VESPA user guide to have more information.