!
! demoSetup.pako
!
! Template for setting up PaKo (H.W., 2007-11-09).
!
! For details, please consult the PaKo manual at
! http://www.iram.es/IRAMES/documents/ncs30mPako/Current/PDF/pako.pdf
!
! NOTE:
! All pako demo procedures assume that the angle unit is arcseconds (see below).
!
SIC PRIORITY 1 PAKO                         ! PAKO commands get precedence
!                                           ! over similar GREG commans!
!
SET Project   111-22                        ! project ID (project number)
SET PI       "Dr. Jane D. Doe"              ! principal investigator
SET Observer "John Doe"                     !
SET Operator  Pako                          !
SET angleUnit arcsec                        ! angle unit for observing modes
SET Topology  low                           ! topology for azimuth 
!
SET Level     3  3                          ! suppress informational messages
!                                           ! ("I-messages") from paKo
!
DEVICE image w                              ! for plots
!
SHOW                                        ! show the values set with set
!
! NOTE: don't use special characters like <, >, &, accents in the names!
!
set doSubmit no                             ! For off-line testing of your 
					    ! procedures with PaKo. We will set
                                            ! doSubmit to "yes" only for 
                                            ! observing.
					    !
!
! NOTE: the following commands define PaKo's input catalogues for objects and
!       spectral lines. Observers can modify or complete these catalogues, but 
!       please do so leaving a comment ("! myComment" at the end of the line,
!       or insert a comment line following your modification).
!
!
! Please replace xxx-yy by your project number, and mySourceCat.sou and
! myLineCat.lin by the names of your source and line catalogues :
!
CATALOG SOU ~/xxx-yy/mySourceCat.sou        ! Source catalogue for the HERA
                                            ! pool. A default version of this
					    ! catalogue is generated from the
					    ! source list in your proposal form.
					    !
CATALOG LIN ~/xxx-yy/myLineCat.lin          ! Catalogue for spectral lines.